hoopie

How to Use an Embroidery Hoop (and Keep Fabric Drum-Tight)

How to put fabric in an embroidery hoop step by step, how tight it should be, where the screw goes, and how to stop fabric slipping while you stitch.

By Ayoub Farid · · 2 min read

Your hoop is the most underrated tool in embroidery. Loose fabric causes wobbly lines, puckering and uneven stitches, and beginners often blame their hands when it's really the hoop. Here's how to hoop fabric properly in under a minute.

How to put fabric in a hoop, step by step

  1. Loosen the screw on the outer ring and separate the two rings.
  2. Place the inner ring (no screw) on a flat surface.
  3. Lay your fabric over it, design side up and centred.
  4. Press the outer ring down over the fabric and inner ring.
  5. Tighten the screw partway.
  6. Tug the fabric edges gently all around, like tightening a drum, keeping the weave straight.
  7. Tighten the screw fully.
  8. Tap the fabric. It should be tight like a little drum and make a soft "tok" sound.

Where should the screw go?

At the top (12 o'clock) for right-handers, or around 10–11 o'clock for left-handers. That keeps your thread from catching on it as you stitch.

How tight is tight enough?

  • Tap test: a drum-like sound.
  • No sagging when you press lightly in the middle.
  • The weave stays straight, not distorted into curves.

Don't over-stretch; if your design is drawn on the fabric, too much pulling distorts it.

Keeping it tight while you stitch

Fabric naturally loosens as you work. Re-tighten every 10–15 minutes: tug the edges and tighten the screw. If it keeps slipping:

  • Wrap the inner ring with cotton twill tape or a bias strip. This adds grip and protects delicate fabric.
  • Use a slightly smaller hoop.
  • Make sure the fabric is the right weight: very slippery fabrics need a backing (stabiliser).

Protect your stitches

Remove the fabric from the hoop when you stop for the day. Leaving it in for weeks can leave a permanent ring mark. When you move the hoop over finished stitches, place a piece of tissue paper between them, then tear it away inside the ring.

Hoop types

TypeProsCons
WoodenLooks great for display, firm gripCan warp if cheap
Plastic with screwStrong grip, durableLess pretty to display
Spring tensionQuick to change fabricLess grip; better for small hoops
Flexi hoops (imitation wood)Display-readyTricky to tighten evenly

Choose a size from embroidery hoop sizes.

Hooping is literally the first step in Hoopie: the "Hoop your fabric" lesson shows the tightening directions with arrows, and the photo coach flags slack fabric if it sees ripples around your stitches.

Frequently asked questions

How tight should fabric be in an embroidery hoop?

Tight like a drum: it should make a soft sound when tapped and not sag when pressed.

Why does my fabric keep loosening in the hoop?

Fabric relaxes as you stitch. Re-tighten regularly, and wrap the inner ring with tape for more grip.

Should the screw be at the top or bottom?

At the top, so your thread doesn't catch on it.

Can I leave fabric in the hoop overnight?

Overnight is fine, but take it out for longer breaks to avoid hoop marks.

Keep reading