How to Thread an Embroidery Needle (Even with 6 Strands)
Easy ways to thread an embroidery needle with multiple strands of floss: the fold method, wetting, flattening and using a needle threader.
By Ayoub Farid · · 2 min read
Threading several strands of floss through a needle eye can be fiddlier than the stitching itself. These methods make it quick, even with six strands.
Before you start
- Cut your floss cleanly with sharp scissors at an angle. A frayed end won't go through.
- Separate the strands you need, then put them back together side by side (embroidery floss guide).
- Use a needle with a long eye: embroidery (crewel) or chenille needles (needles guide).
Method 1: Flatten and push
- Pinch the end of the floss flat between your thumb and finger.
- Hold it so only a tiny bit pokes out.
- Bring the needle eye down onto the floss (move the needle, not the thread).
Method 2: The fold method (best for many strands)
- Fold the floss over the needle shaft, near the eye.
- Pinch the fold tight against the needle.
- Slide the needle out, keeping the fold pinched.
- Push the folded loop through the eye. A fold is flat and firm, so it goes through easily.
Method 3: Moisten the end
A tiny bit of water on the tip (or a damp cloth) holds the strands together. Don't use this if your floss might bleed colour.
Method 4: A needle threader
Push the wire loop of a threader through the eye, put the floss through the loop, and pull it back. Cheap, quick, and handy if your eyesight makes small eyes tricky.
Should I knot the end?
You can tie a small knot at the end, which is easiest for beginners. Many stitchers prefer knot-free starts (a waste knot or a loop start) so the back stays flat. See how to start and end embroidery thread.
Single or double thread?
In embroidery, you usually don't double the thread over (that's for sewing). Pull a short tail through the eye, about 8–10 cm, and stitch with the long end. The loop start is an exception: with an even number of strands, you fold one long strand in half to get two strands, and the loop anchors your first stitch.
Common problems
| Problem | Fix |
|---|---|
| Strands split around the eye | Use the fold method |
| Floss frayed | Trim at an angle |
| Eye too small | Use a bigger needle (smaller number) |
| Needle unthreads as you stitch | Leave a longer tail, or hold it as you work |
Frequently asked questions
How do you thread a needle with embroidery floss?
Fold the floss over the needle, pinch the fold, slide the needle out and push the folded loop through the eye.
Do you double embroidery thread?
Usually no. Separate the strands you need and use them as a single bundle, with a short tail at the eye.
What if I can't see the needle eye?
Use a needle threader, a larger-eye needle and good light.
How much tail should I leave?
About 8–10 cm, so the needle doesn't slip off as you stitch.